Cut-to-length lines
Automatic roll metal cut-to-length lines produced by the company “Arkada-Engineering” it is an effective and high quality solution for metal cutting into sheets.
The technology of sheet metal cutting demands high quality equipment. “Arkada-Engineering” cut-to-length lines it is an optimal solution for those who want to get high quality production using contemporary equipment with levelers of extended precision. Offered lines are produced with broad bandwidth of characteristics: thickness from 0,25 to 6,0mm. with initial procurement width from 600 to 1650 mm.
The equipment is used for various metal kinds: cold roll steel, galvanized steel, metals with decorative and polymeric coverings, aluminium etc. Worked material thickness reaches 6,0 mm. At the same time cutting speed depending on the line completing can reach 60m/min. Initial roll material weight is also determined by the customer’s demands. Lifting and decoiling mechanisms work in the range of from 5 to 20 tons. The lines are controlled by contemporary electrical systems of various modifications which guarantee high precision of sheet cutting and leveling. Having considered your demands the specialists of “Arkada-Engineering” will offer the optimal solution which will allow to obtain the required accordance of price, output and quality of produced items.
Distinctive qualities:
- Production quality
- High cutting speed and precision
- Wide possibility to complete the line with components from foreign producers: executive units, completing and leveling machines
- Contemporary electronic control
- Automatic defects diagnostics
- Accordance to CE certificate
Technical specifications:
We offer you the standard solution for roll metal cut-to-length line:
| Material |
cold roll steel according to the State Standard 19904, galvanized or decorative covering according to the State Standard 14918 |
| Tensile strength, Mpa |
up to 490 |
| Thickness, mm |
0,3..2,0 |
| Width, mm |
600..1250 |
| Inner coil diameter, mm |
500, 600 |
| Outer coil diameter, mm |
650..1500 |
| Maximum coil weight, T |
10 |
Items specifications:
| After cross cutting minimum sheet length, mm |
400 |
| After cross cutting maximum sheet length, mm |
6000 |
| Sheet pack maximum height, mm |
500 |
| Sheet pack maximum weight, T |
5 |
Technical specifications of the line:
| Working mode |
automatic |
| Coil loading mode |
semiautomatic |
| Strip feeding mode |
semiautomatic |
|
Decoiler drum diameter, mm |
| — with removable covers |
600 (560..620) |
| — without covers |
500 (460..520) |
|
| Cross cutting precision |
according to the State Standard 19904 (for extended precision) |
| Sheet leveling quality |
according to the State Standard 19904 (for high flatness) |
| Cut sheet camber |
according to the State Standard 19904-90 |
| Sheet cross cutting repetition factor, mm |
5 |
|
Output of the line: |
| — with sheet length 6000mm, linear m/min |
up to 50 |
| — with sheet length 4000mm, linear m/min |
up to 40 |
| — with sheet length 3000mm, linear m/min |
up to 35 |
| — with sheet length 2000mm, linear m/min |
up to 25 |
| — with sheet length 1000mm, linear m/min |
up to 15 |
| — with sheet length 400mm, linear m/min |
up to 5 |
|
| Approximate line dimensions, mm |
| — length |
20000 |
| — width |
8500 |
| — height |
2500 |
|
| Approximate line weight, T |
35 |
| Approximate installed capacity, kW |
100 |
| Current type |
alternating |
| Voltage, V |
380/220 |
|
“Arkada-Engineering” limited company
